www.ccsenet.org/jmr Journal of Mathematics Research Vol. 3, No. 1 February 2011 Development of Empirical formula Prediction on Critical Impact Energy for Perforation Phenomena on Concrete Structures Qadir Bux alias Imran Latif Faculty of Civil and Environmental Engineering, Universiti Tun Hussein Onn Malaysia (UTHM) 86400, Parit Raja, Johor, Malaysia Tel: 60-1-9701-3878 E-mail: imranqazi37@gmail.com Ismail Abdul Rahman Faculty of Civil and Environmental Engineering, Universiti Tun Hussein Onn Malaysia (UTHM) 86400, Parit Raja, Johor, Malaysia Tel: 60-1-2787-6360 E-mail: ismailar@uthm.edu.my Ahmad Mujahid Ahmad Zaidi (Corresponding author) Department of Mechanical Engineering, Faculty of Engineering, National Defence University (UPNM) Kem Sungai Besi, 57000 Kuala Lumpur, Malaysia Tel: 60-1-7478-3139 E-mail: mujahid@upnm.edu.my Abstract Concrete is basic construction material used for most structures. However, the vital structures have to be designed as self- protective such as nuclear plants, power plants, weapon industries, weapons storage places, water retaining structures, highway structures, and etc. These structures should have to be offer self shield against any natural disaster tragedy incidents and intentionally produced horrible incidents such as dynamic loading, incident occurs in nuclear plants, terrorist attack, missile attack, tsunami and etc. In modern science, the impact energies are crucial way to study the local impact effects on concrete structures together with the influence of relative target thickness (H/d). This study is focused on minimum required kinetic energy for perforation of the concrete structures generated by flat nose hard missile in terms of relative target thickness (H/d), by using curve fitting empirical study with the implementation of dimensional analysis of non-dimensional numbers. For verification, the proposed developed empirical formula was well compared with other established empirical formulae such as NDRC, UMIST and Semi Empirical formulae and it is expected that the outcome of the proposed formulae can be applied in design recommendations and design procedures for determining the dynamic reaction of the concrete target to foil perforation of flat nose hard missile. Keywords: Perforation, Concrete, Critical, Kinetic energy, Empirical, Flat nose, Hard missile 1. Introduction Over the years, concrete is very commonly used construction material for the defensive and civil applications to protect structures from local and explosive impact loads. The effects of the local impact of hard missile on concrete structures have been studied since the mid of 17th century because of continuous military interest in designing high performance missiles and high performance protective barriers. Projectile exists in a long range with variation in sizes, shapes, velocity, weight, density, hardness, such as bullets, fragments, tornado, bomb, missile etc. The projectile may be classified as ’Hard’ and ’Soft’ depending upon deformability of projectile with respect to target’s deformation (Kennedy 1976), (Q. M. Li et al 2005), and (P. Koechlin and S. Potapov 2009). Deformation of hard missile is considerable smaller or negligible compared with target’s deformation. Almost in all cases hard missiles are considered as non - deformable or rigid. However, ’Soft’ missile deforms itself considerably well as compared to target’s deformation (Kennedy 1976), (Q. M. Li et al 2005), and (P. Koechlin and S. Potapov 2009). In general, the local impact effect of hard missile on concrete structures can be studied in three ways, (i). Empirical Studies (predict empirical formula based on experimental data), (ii). Analytical Studies (create formula based on physical laws and compared with experimental data), and (iii), Numerical Simulation (based on computer based material model generate results and compared with experimental data). Empirical formulae based on experimental data are especially important in this field due to the complexity of the local impact phenomena. Some of these have been summarized in previous review papers. However, particular empirical formulae for perforation limits are often formulated by curve-fitting test data and most of them are unit-dependent and limited by the range of the validity, and only being applicable strictly within the limits Published by Canadian Center of Science and Education 83

www.ccsenet.org/jmr Journal of Mathematics Research Vol. 3, No. 1 February 2011 of the tests from which the data were acquired (Kennedy 1976 and Q. M. Li et al 2005). Critical impact kinetic energy is essential technique to determine the local impact effects. The way in which the kinetic energy is distributed through the concrete target is also noteworthy in determining its response against local impact effects (perforation). Literature review showed that fine-looking work have been done on predictions of perforation. This study shows the influence of relative target thickness (H/d) on the required critical impact kinetic energy which may cause the complete or just perforation in concrete targets, when it is subjected to the impact of flat nose hard missile. This study is based on empirical formula predicted by using curve fitting data method by polynomial equation. 2. Literature Review The effects of the local impact of hard missile on concrete structures have been studied since the mid of 17th century because of continuous military interest in designing of high performance missiles and high performance protective barriers (Q.M. Li et al 2005). A review of research work exposed that peak studies about concrete structures against dynamic loading were conducted from the early 1940s (Z. Liang, et al 2007). However, most of the research work ceased shortly after World War - II and was not resumed until 1960s (Z. Liang, et al 2007). The intensive study on concrete targets against local impact effects of hard missiles in the nuclear industry re-initiated since five decades ago. Kennedy (1976) provided an early review of the concrete response against local impact effects of hard missile for nuclear industries and recommended impact force time history theory (Kennedy 1976 and Q. M. Li et al 2005). Various empirical studies were conducted to explore local impact effects of hard missile on concrete structures, a review of these studies were discussed intensively in previous publications, e.g., Kennedy (1976), Bangash (1993), Williams (1994), Corbett et al. (1996), and Q.M Li (2005). The extensive empirical studies were conducted in past for predicting the perforation limit, the most used empirical formulae for designing of concrete structures to overcome perforation of hard missile are Modified Petry formula, Ballistic Research Laboratory (BRL) formula, Army corps of engineers (ACE) formula, Modified NDRC formula (Q. M. Li et al 2005). Other than these Degen perforation formula, Hughes formula based on tensile strength of concrete, also can be used to predict perforation limit for concrete targets (Q. M. Li et al 2005). It is noted that all above mentioned empirical formulae used to predict perforation limits are dependent of penetration depth. Furthermore, UKAEA formula based on Barr’s assumptions for ballistic limit, CEA - EDF perforation formula for reinforced concrete, and Criepi formula are used to predict perforation limit of concrete (Q. M. Li et al 2005). Critical impact kinetic energy is essential technique to determine the local impact effects. It is essential to determine the effects of kinetic energy and relative target thickness on local impact effect with dimensional analysis of non-dimensional numbers (Q. M. Li et al 2006). The critical impact kinetic energy, which can produce perforation in to the concrete target with the impact of hard missile, can be calculated by using empirical formula derived by UMIST (Q. M. Li et al 2005). Furthermore, Q.M. Li et al (2006) modified the UMIST, NDRC, and Semi empirical formula for required critical impact energy to perforate concrete targets impacted with flat nose hard missile in terms of dimensional analysis of non - dimensional numbers (Q. M. Li et al 2006). However, literature recommends that the NDRC formula predicts more accurate results among all other above mentioned formulae (Kennedy 1976 and Q. M. Li et al 2005). 3. Local Impact Effects Local impact effect is briefly sub-divided in below explained processes: 3.1 Radial Cracking When projectile colloids with concrete target with certain velocity, it results radial cracks originated from the point of impact within the target in every direction (Q. M. Li et al 2005). 3.2 Spalling The ejection of material of target from front face (impacted face) due to impact of hard projectile is called spalling. Spalling produces spall crater in the surrounding area of impact. Spall crater is the total damaged portion of peeling off material from target on impacted face (Kennedy 1976 and Q. M. Li et al 2005). 3.3 Penetration Penetration is defined as the digging of missile into the target body afar from the thickness of spall crater. The lengthwise measurement of dig is called penetration depth (Kennedy 1976 and Q. M. Li et al 2005). 3.4 Cone cracking and Plugging During penetration missile colloids with rear border of target and generates curved shear cracks in the shape of bell plug is called cone cracking. And than missile continues penetrating through target, it forces plug and shears-off the surrounding material of target is called plugging. This process generates rapid change into the behavior of target (Q. M. Li et al 2005). 3.5 Scabbing Ejection of target material from back face of target is called scabbing (Kennedy 1976 and Q. M. Li et al 2005). 84 ISSN 1916-9795 E-ISSN 1916-9809