In vitro characterisation of low-cost synthetic meshes intended for hernia repair in the UK

Abstract

Purpose: Low-cost meshes (LCM) were repurposed for the repair of hernias in the developing world. In vivo studies have shown LCM to have comparable results to commercial meshes (CM) at a fraction of the cost. However, little has been done to characterise the mechanical and biocompatible properties of LCM, preventing its clinical use in the UK. The objectives of the research are to assess mechanical and ultrastructural properties of two UK-sourced low-cost meshes (LCM) and the characterisation of the LCMs in vitro biocompatibility. Methods: Mechanical properties of the two LCM were measured through uniaxial tensile test and ultrastructure was evaluated with Scanning Electron Microscopy. LIVE/DEAD® Viability/Cytotoxicity Assay kit and alamarBlue were used to assess cellular viability and proliferation, respectively. Images were acquired with a fluorescence microscope and analysed using ImageJ (NIH, USA). Results: LCM1 and LCM2 were both multifilament meshes, with the first having smaller pores than the latter. LCM1 exhibited significantly higher tensile strength (p < 0.05) than LCM2 but significantly lower extensibility (p < 0.0001), while Young’s Modulus of the two samples was not significantly different. No significant difference was found in the cellular viability and morphology cultured in LCM1 and LCM2 conditioned media. Metabolic assay and fluorescence imaging showed cellular attachment and proliferation on both LCMs over 14 days. Conclusion: The characterisation of the two UK-sourced LCMs showed in vitro biocompatibility and mechanical and ultrastructural properties comparable to the equivalent CM. This in vitro data represents a step forward for the feasibility of adopting LCM for surgical repair of hernias in the UK.