Discrete vortex-based broadcast mode analysis for mitigation of dynamic stall

Abstract

We integrate a discrete vortex method (DVM) with complex network analysis to strategise dynamic stall mitigation over aerofoils with active flow control. The objective is to inform the actuator placement and the timing to introduce control inputs during the highly transient process of dynamic stall. To this end, we treat a massively separated flow as a network of discrete vortical elements and quantify the interactions among the vortical nodes by tracking the spread of displacement perturbations between each pair of vortical elements using a DVM. This allows us to perform network broadcast mode analysis to identify an optimal set of discrete vortices, the critical timing and the direction to seed perturbations as control inputs. Motivated by the objective of dynamic stall mitigation, the optimality is defined as maximising the reduction of total circulation of the free vortices generated from the leading edge over a prescribed time horizon. We demonstrate the use of the analysis on a two-dimensional flow over a flat plate aerofoil and a three-dimensional turbulent flow over an SD 7003 aerofoil. The results from the network analysis reveal that the optimal timing for introducing disturbances occurs slightly after the onset of flow separation, before the shear layer rolls up and forms the core of the dynamic stall vortex. The broadcast modes also show that the vortical nodes along the shear layer are optimal for introducing disturbances, hence providing guidance to actuator placement. Leveraging these insights, we perform nonlinear simulations of controlled flows by introducing flow actuation that targets the shear layer slightly after the separation onset. We observe that the network-guided control results in a 21% and 14% reduction in peak lift for flows over the flat plate and SD 7003 aerofoil, respectively. A corresponding decrease in vorticity injection from the aerofoil surface under the influence of control is observed from simulations, which aligns with the objective of the network broadcast analysis. The study highlights the potential of integrating the DVMs with the network analysis to design an effective active flow control strategy for unsteady aerodynamics.