Using small diameter logs for cross-laminated timber production

Abstract

Sawing small diameter logs results in lower yield compared to sawing large diameter logs. This is due to geometry; fitting rectangular blocks inside an approximately cylindrical shape is more difficult for small than for large diameters. If small diameter logs were sawn in a way that follows the outer shape, yield would increase. The present study considers whether this can be done by sawing flitches into trapeze shapes. These can be glued together into rectangular products. Cross laminated timber (CLT) products are suitable for this. The study was based on 4,860 softwood logs that where scanned, and the scanning data was used for sawing simulation. The log top diameters ranged from 92 to 434 mm. The volume yield of CLT production using trapeze edging was compared to cant sawing of boards. The trapeze edging and CLT production process improved yield compared to cant sawing by 17.4 percent units, for logs of a top diameter smaller than 185 mm. For all logs, the yield decreased using the trapeze edging method. To conclude, a trapeze edging method shows promise in terms of increasing volume yield for small diameter logs, if boards can be properly taken care of in a CLT production process.