Impact of blocking layers based on TiO2 and ZnO prepared via direct current reactive magnetron sputtering on DSSC solar cells

Abstract

The optimization of dye-sensitized solar cells (DSSCs) technology towards suppressing charge recombination between the contact and the electron transport layer is a key factor in achieving high conversion efficiency and the successful commercialization of this type of product. An important aspect of the DSSC structure is the front blocking layer (BL): optimizing this component may increase the efficiency of photoelectron transfer from the dye to the semiconductor by reduction charge recombination at the TiO2/electrolyte and FTO/electrolyte interfaces. In this paper, a series of blocking layer variants, based on TiO2 and ZnO:TiO2, were obtained using the reactive magnetron sputtering method. Material composition, structure and layer thickness were referred to each process parameters. Complete DSSCs with structure FTO/BL/m-TiO2@N719/ EL-HSE/Pt/FTO were obtained on such bases. In the final results, verification of opto-electrical parameters of these cells were tested and used for the conclusions on the optimal blocking layer composition. As the conclusion, application of blocking layer consists of neat TiO2 resulted in improvement of device efficiency. It should be noted that for TiO2:ZnO/CuxO and TiO2/CuxO cells, higher efficiencies were also achieved when pure TiO2 was used as window layer. Additionally it was proven that the admixture of ZnO phase inspires Voc and FF growth, but is overall unfavorable compared to pristine TiO2 blocking layer and the reference cell, according to the final cell efficiency.