Shear wave velocity model of the Santiago de Chile basin derived from ambient noise measurements: A comparison of proxies for seismic site conditions and amplification

Abstract

We determined a high-resolution 3-D S-wave velocity model for a 26 km × 12 km area in the northern part of the basin of Santiago de Chile. To reach this goal, we used microtremor recordings at 125 sites for deriving the horizontal-to-vertical (H/V) spectral ratios that we inverted to retrieve local S-wave velocity profiles. In the inversion procedure, we used additional geological and geophysical constraints and values of the thickness of the sedimentary cover already determined by gravimetric measurements, which were found to vary substantially over short distances in the investigated area. The resulting model was derived by interpolation with a kriging technique between the single S-wave velocity profiles and shows locally good agreement with the few existing velocity profile data, but allows the entire area, as well as deeper parts of the basto be represented in greater detail. The wealth of available data allowed us to check if any correlation between the S-wave velocity in the uppermost 30 m (v30S) and the slope of topography, a new technique recently proposed by Wald and Allen, exists on a local scale. We observed that while one lithology might provide a greater scatter in the velocity values for the investigated area, almost no correlation between topographic gradient and calculated v30S exists, whereas a better link is found between v30S and the local geology. Finally, we compared the v30S distribution with the MSK intensities for the 1985 Valparaiso event, pointing out that high intensities are found where the expected v30S values are low and over a thick sedimentary cover. Although this evidence cannot be generalized for all possible earthquakes, it indicates the influence of site effects modifying the ground motion when earthquakes occur well outside of the Santiago basin. © 2010 The Authors Journal compilation © 2010 RAS.