Laminar separation bubble formation and bursting on a finite wing

Abstract

The transient processes of laminar separation bubble (LSB) formation and bursting on a rectangular NACA 0018 wing are studied experimentally. A two-dimensional airfoil model is used as a baseline for the assessment of finite wing effects. The models are subjected to ramp changes in free-stream velocity causing the flow to switch between a state where an LSB forms and a state without reattachment. Lift force and particle image velocimetry measurements are used to relate the flow development to the aerodynamic loading. The lift coefficient of the airfoil exhibits substantial hysteresis, and the duration of the lift transients range from to convective time scales for bubble formation and to convective time scales for bursting. In contrast, the transient lift coefficients of the wing change gradually, with less hysteresis. The wing tip causes greater three-dimensionality in the separation bubble, whose thickness increases near the midspan where bursting is initiated. During bubble formation, the region of separated flow contracts towards the midspan. The gradual change in lift of the wing is linked to slower spanwise expansion and contraction of the separated flow region relative to the airfoil. On both models, the wavenumbers and amplitudes of disturbances in the separated shear layer rapidly change when reattachment initiates or ceases. Applying the bursting criterion of Gaster (Tech. Rep. Reports and Memoranda 3595. Aeronautical Research Council, London, 1967) to the bubble on the wing shows that bursting of the bubble at a single spanwise location is insufficient to cause complete spanwise failure of reattachment, and that the relationship between bursting parameters depends on spanwise position.