Effect of pin hole size and number on in vitro bone strength in the equine radius loaded in torsion

Abstract

Objective - To determine the effect of pin hole size and number on the breaking strength of the adult equine radius when loaded in torsion to failure. Sample Population - 54 pairs of equine radii from adult horses. Procedure - For test one, 12 pairs of radii were used to determine the effect of pin hole size on torsional breaking strength. A 6.35-mm hole was drilled in 1 radius, and a 9.5-mm hole was drilled in the contralateral radius. For test two, 36 pairs of radii were randomly assigned to 1 of 3 treatment groups (n = 12) to determine the effect of pin hole number on the torsional breaking strength of the equine radius. One radius of each pair served as a control, and one, three, or six 6.35-mm transcortical holes were drilled in the contralateral radius. For test three, 6 pairs of radii had torsional forces applied directly to the transfixation pins, as opposed to the bone itself. One radius of a pair served as a control, and three 6.35-mm smooth Steinman pins were placed in the contralateral radius. All radii were loaded in torsion to failure, and the breaking strengths were recorded. Results - Compared with the 6.35-mm hole, the 9.5-mm hole significantly decreased torsional strength of the radius. There was no significant difference in mean torsional strength between the control radii and the radii with 1, 3, or 6 transcortical holes or when the transfixation pins were loaded. Conclusion - Use of up to three 6.35-mm transfixation pins can be used in a full-limb transfixation pin cast to optimize stiffness without a significant decrease (12%) in bone strength.