Impact of photoinitiator quality on chemical-mechanical properties of dental adhesives under different light intensities

Abstract

Objective: Evaluate the mechanical properties of experimental adhesive models with different photoinitiators (PI) polymerized by LED units of different power densities. Material and Methods: Three groups of adhesive models based on HEMA/BisGMA (45/55) were prepared in association with different PI combinations: G2 (control) – 2 PI: 0.5% CQ, 0.5% EDMAB; G3-3 PI: 0.5% CQ; 0.5% DMAEMA, 0.5% DPIHP; G4-4 PI: 0.5% CQ; 0.5% EDMAB; 0.5% DMAEMA; 0.5% DPIHP. The three formulations were polymerized at two different LED power densities: 550 mW/cm2 and 1200 mW/cm2. The degree of conversion (DC) of adhesive monomers was monitored in situ through the FTIR for 600 s. Specimens were prepared for each formulation for analysis of flexural strength (FS), modulus of elasticity (ME), sorption (SOR) and solubility (SOL). Data were submitted to two-way ANOVA and Tukey tests (5%). Results: DC: there is a significant difference among adhesive systems (G2