Investigation into recycled rubber aggregates and steel wire fiber for use in concrete subjected to impact loading

Abstract

This study investigated the potential use of tire derived rubber aggregates, particularly powdered rubber, and recycled steel-wire fibers in concrete subjected to impact loading. The fibers are approximately 0.4 mm in average diameter and 25 mm in length on average. There are two main portions to this study. The first phase of this study involved small-scale batching to investigate the fresh and hardened properties of concrete mixtures with powdered rubber up to 50% replacement of sand volume and recycled steel fibers up to 0.25% by mixture volume. Additional mixtures containing powdered rubber, crumb rubber, and tire chips were evaluated for their mechanical performance. Based on fresh concrete properties, compressive strength, modulus of rigidity, and impact resilience, mixtures were selected for a second investigative phase. In this phase, static and impact testing were performed on two sets of scaled beams. One beam set was produced with concrete containing 40% powdered rubber as a sand replacement and another beam set with a combination mixture incorporating rubber products of varying sizes (10% powdered rubber, 10% crumb rubber, and 10% tire chip) and 0.25% recycled steel fiber. Flexural performance improved initially with the inclusion of powdered rubber but decreased with increasing concentrations. Mixtures including recycled steel fibers at 0.25% outperformed industrial steel fiber mixtures in both flexural strength and impact resistance. For both the static and impact beams with the recycled powdered rubber and steel fibers in the combination demonstrated improved load distribution and load-carrying capacity, acting as a sufficient replacement for industrial steel fiber reinforcement.