Mode conversion behavior of guidedwave in a pipe inspection system based on a long waveguide

5Citations
Citations of this article
16Readers
Mendeley users who have this article in their library.

Abstract

© 2016 by the authors; licensee MDPI, Basel, Switzerland. To make clear the mode conversion behavior of S0-mode lamb wave and SH0-plate wave converting to the longitudinal mode guided wave and torsional mode guided wave in a pipe, respectively, the experiments were performed based on a previous built pipe inspection system. The pipe was wound with an L-shaped plate or a T-shaped plate as the waveguide, and the S0-wave and SH0-wave were excited separately in the waveguide. To carry out the objective, a meander-line coil electromagnetic acoustic transducer (EMAT) for S0-wave and a periodic permanent magnet (PPM) EMAT for SH0-wave were developed and optimized. Then, several comparison experiments were conducted to compare the efficiency of mode conversion. Experimental results showed that the T(0,1) mode, L(0,1) mode, and L(0,2) mode guided waves can be successfully detected when converted from the S0-wave or SH0-wave with different shaped waveguides. It can also be inferred that the S0-wave has a better ability to convert to the T(0,1) mode, while the SH0-wave is easier to convert to the L(0,1) mode and L(0,2) mode, and the L-shaped waveguide has a better efficiency than T-shaped waveguide.

Cite

CITATION STYLE

APA

Sun, F., Sun, Z., Chen, Q., Murayama, R., & Nishino, H. (2016). Mode conversion behavior of guidedwave in a pipe inspection system based on a long waveguide. Sensors (Switzerland), 16(10). https://doi.org/10.3390/s16101737

Register to see more suggestions

Mendeley helps you to discover research relevant for your work.

Already have an account?

Save time finding and organizing research with Mendeley

Sign up for free