A three-phase mixed columnar-equiaxed solidification model is used to calculate the macrosegregation in a 2.45 ton steel ingot. The main features of mixed columnar-equiaxed solidification in such an ingot can be quantitatively modelled: growth of columnar dendrite trunks; nucleation, growth and sedimentation of equiaxed crystals; thermosolutal convection of the melt; solute transport by both convection and crystal sedimentation; and the columnar-to-equiaxed transition (CET). The predicted as-cast macrostructure and the segregation pattern are in qualitative agreement with the reported experimental results. Parameter study on the numerical grid size and the nucleation of the equiaxed crystals are performed, and some segregation mechanisms are numerically analyzed. Discontinued positive-negative segregation just below the hot top is predicted because of the formation of a local mini-ingot and the subsequent sedimentation of equiaxed grains within the mini-ingot. Quasi A-segregates in the middle radius region between the casting outer surface and the centreline are also found. The quasi A-segregates originate from the flow instability, but both the appearance of equiaxed crystals and their interaction with the growing columnar dendrite tips significantly strengthen the segregates. The appearance of equiaxed phase is not a necessary condition for the formation of quasi A-segregates. The quantitative discrepancy between the predicted and experimental results is also discussed. © 2013 The Authors. Published by Elsevier Ltd. All rights reserved.
Li, J., Wu, M., Ludwig, A., & Kharicha, A. (2014). Simulation of macrosegregation in a 2.45-ton steel ingot using a three-phase mixed columnar-equiaxed model. International Journal of Heat and Mass Transfer, 72, 668–679. https://doi.org/10.1016/j.ijheatmasstransfer.2013.08.079