We demonstrate a polymer rib waveguide Young interferometer sensor fabricated by UV-imprinting. An inverted rib waveguide structure was utilized in order to simplify the fabrication process. In this configuration grooves are formed on the under cladding layer by UV-imprinting and core material is spin coated on top to fill the grooves. Glucose water solution was used to characterize the sensor response against ambient refractive index changes. The sensing responses correspond linearly with the refractive index change of glucose solutions with a detection limit of about 10-5. To verify the capability of the polymer sensor for biosensing, an immunoassay was performed with c-reactive protein (CRP) and human CRP specific antibody adsorbed on the waveguide surface as a receptor. The CRP solution in PBS (phosphate buffered saline) buffer with a concentration of 2 µg/ml (16 nM) resulted in an obvious response which was over a couple hundred times of the noise level. Based on these values, a detection limit of about 2.4 pg/mm2 was found for the surface sensing of molecular adsorption. With the proposed waveguide configuration, the fabrication of polymer sensors can be ultimately transferred to roll-to-roll mass production to produce low-cost disposable sensors.
Mendeley saves you time finding and organizing research
Choose a citation style from the tabs below