The effect of injection process for microcellular foaming on the cell morphology and surface quality of Polyamide 6

Abstract

Microcellular foamed polymers have been widely used in the traffic field. However, it is difficult to successfully manufacture microcellular foamed products that simultaneously possess good cell morphology, small size, high cell density, and great surface quality. In this paper, polyamide 6 (PA6) injection microcellular foams were manufactured via short-shot and core-back foaming process to investigate the effect of the foaming process on cell quality and surface quality. Results showed that the core-back injection PA6 foams possessed a smaller cell size, higher cell density, lower cell deformation, and greater surface glossiness than short-shot foams. The cell density of core-back PA6 microcellular foams reached to 12.5 × 105 cell/cm3, which is almost 3.5 times greater than that of the short-shot foams when the weight reduction was 10%. The PA6 microcellular foams manufactured via the coreback foaming process had higher surface glossiness with different weight reduction, whereas the surface glossiness of short-shot microcellular foams dramatically declined with an increase in weight reduction. Hence, the core-back foaming process can be used to fabricate microcellular foamed polymers with good cell morphology, small size, high cell density, and fine surface quality under high weight reduction; this was beneficial for producing products that have good surface quality and high weight reduction and are used in automobiles, high-speed trains, and airplanes to reduce energy consumption.