Structural and optical properties of Zn doped CuInS2 thin films

Abstract

Copper indium sulphide (CIS) films were deposited by spray pyrolysis onto glass substrates from aqueous solutions of copper (II) sulphate, indium chloride and thiourea using compressed air as the carrier gas. The copper/indium molar ratio (Cu/In) in the solution 1(1:1) and the sulphur/copper ratio (S/Cu) was fixed at 4. Structural properties of these films were characterized. The effects of Zn (0-5%)molecular weight compared with CuInS2 Source and different substrate temperatures on films properties were investigated using X-ray diffraction (XRD) and optical transmission spectra. Optical characteristics of the CuInS2 films have been analysed using spectrophotometer in the wavelength range 300-1100 nm. The absorption spectra of the films showed that this compound is a direct bandgap material and gap values varied between 1.55 and 1.57 eV, depending on the substrate temperatures. Zn-doped samples have a bandgap energy of 1.55-1.95 eV. It was observed that there is an increase in optical bandgap with increasing Zn % molecular weight. The optical constants of the deposited films were obtained from the analysis of the experimentally recorded transmission and absorption spectral data. The refractive index, n and dielectric constants, ε1 and ε2, were also discussed and calculated as a function of investigated wavelength range and found it dependent on Zn incorporation. We found that the Zn-doped CuInS 2 thin films exhibit P-type conductivity and we predict that Zn species can be considered as suitable candidates for use as doped acceptors to fabricate CuInS2-based solar cells. The paper presents a study concerning the influence of deposition parameters (temperature of the substrate and concentration of Zn (1-5)% from 0.16 M ZnCl2) on the quality of CuInS 2 thin films achieved by spray pyrolysis on glass substrate from solutions containing 0.02 M CuCl2.2H2O, 0.16 M thiourea and 0.08 M In2Cl2.5H2O. © Indian Academy of Sciences.