Using the ratio: Maximum load over unload stiffness squared, Pm/Su2, on the evaluation of machine stiffness and area function of blunt indenters on depth-sensing indentation equipment

Abstract

Depth sensing indentation study was conducted in a Fischerscope H100V machine, equipped with a Vickers indenter with a tip roundness of approximately 1330 nm. Tests were carried out on soda-lime glass, fused silica, sapphire, aluminum (1100 alloy), high alloyed steel, titanium and coppr.The widely used iterative method of Oliver and Pharr was unsuccessful in the attempts to analyze machine compliance and indentor area function. Therefore, an alternative procedure was adopted. The alternative procedure it based on the ratio-between maximum load and unload stiffness squared, Pm/Su2. It was found that this procedure, which is not iterative, gives good results. A careful study of the Pm/Su2 ratio, lead us to conclude that the Fischercope machine has a low compliance which depends on the sample mounting. This low compliance in conjunction with the recent discovery of the dependence of β factor on the tip roundness/maximum depth ratio, which appears in the relation between contact stiffness and contact area, explains why the iterative method does not converge. However, variations in β and machine compliance produces deviation on the hardness and elastic modulus lower that 6% With respect to expected values for the materials and the machine studied in this work.