Manufacturing of cast in situ ultra high performance fibre reinforced concrete (uhpfrc)-Workability, Tensile and Compressive Strength

Abstract

The aim of this article is to share on the manufacturing process of Ultra High Performance Fibre Reinforced Concrete (UHPFRC) without heat curing or steam curing, hence, it makes UHPFRC possible to be used for in situ application. The common materials used in numerous previous studies were used in this work to produce UHPFRC: Cement type CEM I, fine sand, silica fume, water and third generation high range water reducer. Three tests were conducted, i.e. Compression test and slump flow test and tensile test. The targeted slump flow is in the range of 600 mm to 750 mm, minimum targeted compressive strength and tensile strength test is 115 MPa and 10 MPa, respectively. In addition, the UHPFRC must exhibit strain hardening properties. As a result, this study proposes the mix proportion of the above mentioned material used to produce UHPFRC which is suitable to be utilized for in situ application.