Abstract
The objective of this research is to investigate the optimum aluminum powder content in epoxy as adhesive and surface pattern on shear strength of single lap joint between aluminum-GFRP composite for electric car application. The shear strength was determined by utilizing the single-lap shear test. The aluminum powder content was varied in 0, 2.5, 5, 7.5,10 and 12.5(w/w), whereas the surface pattern varied in 5 type of pattern. Experimental results showed that the aluminum powder-epoxy adhesive has the maximum shear strength at 12.5% of aluminum powder content. However, for the use of the surface pattern on adherend shows slight differences of shear strength. The adhesive failure mode occurred the joining using aluminum powder-epoxy as mixed mode.
Author supplied keywords
Cite
CITATION STYLE
Diharjo, K., Firdaus, Y., Raharjo, W. W., & Tjahjana, D. D. D. P. (2014). Improvement of strength on joint of GFRP/A1-5083 joint using Epoxy/Al-powder adhesive for electric vehicle car body. In Proceedings of 2014 International Conference on Electrical Engineering and Computer Science, ICEECS 2014 (pp. 193–196). Institute of Electrical and Electronics Engineers Inc. https://doi.org/10.1109/ICEECS.2014.7045244
Register to see more suggestions
Mendeley helps you to discover research relevant for your work.
