Experimental investigation of microscale mechanisms during compressive loading of paperboard

Abstract

Compression of paperboard is a common procedure during industrial package forming and better knowledge of the material response is needed to avoid defective packages and waste. To go beyond current modelling approaches, experimental identification of mechanisms underlying the macroscopic stress–strain responses is needed. In this study, in-situ uniaxial compression of paperboard is studied through synchrotron tomography at high spatiotemporal resolutions. Both the microstructural evolution of the fibre network and the actual boundary conditions of the loading were quantified and analysed. At the microscale, the loading equipment plates were not perfectly flat resulting in an increasing sample-equipment contact area with loading. This is, however, shown to only have a small effect on the form of the macroscopic stress–strain curves. The evolution of 3D strain fields showed that strain accumulated close to the sample surfaces in the early part of the compression process, whereafter the main deformation zone shifted to the out-of-plane centre. Both fibre walls and pore volumes were observed to decrease during loading (and recover partly after unloading). Regarding the pore volume, the main reduction mechanism was seen to be closure of layers between fibres. Even if the total pore volume reduction was seen to be the dominant deformation mechanism in a second stage of compression, the volumetric change of fibre walls was non-negligible. Fibre wall compression is not commonly considered in theoretical treatments of paperboard compression, but this work suggests that the stored elastic energy could be a driver for the elastic recovery of the fibre network during unloading.