Fabrication and properties of electrospun and electrosprayed polyethylene glycol/polylactic acid (Peg/pla) films

Abstract

Polylactic acid (PLA) film is an alternative filter material for heat-not-burn (HNB) tobacco, but its controllability in cooling performance is limited. In this work, polyethylene glycol (PEG) was introduced to form a polyethylene glycol/polylactic acid (PEG/PLA) film by electrospinning or electrospraying techniques to enhance the cooling performance, due to its lower glass transition and melting temperatures. The PEG/PLA films with typical electrospun or electrosprayed morphologies were successfully fabricated. One typical endothermic peak at approximately 65◦ C was clearly observed for the melting PEG phase in the heating process, and the re-crystallization temperature represented by an exothermic peak was effectively lowered to 90–110◦ C during the cooling process, indicating that the cooling performance is greatly enhanced by the introduction of the PEG phase. Additionally, the wetting properties and adsorption properties were also intensively studied by characterizing the contact angles, and the as-prepared PEG/PLA films all showed good affinity to water, 1,2-propandiol and triglyceride. Furthermore, the PEG/PLA film with a PLA content of 35 wt.% revealed the largest elasticity modulus of 378.3 ± 68.5 MPa and tensile strength of 10.5 ± 1.1 MPa. The results achieved in this study can guide the development of other filter materials for HNB tobacco application.