Stability Testing of PtxSn1 − x/C Anodic Catalyst for Renewable Hydrogen Production Via Electrochemical Reforming of Ethanol

Abstract

The stability testing of three different synthesized PtxSn1 − x/C anodic catalysts has been demonstrated for the renewable generation of hydrogen via the electrochemical reforming of ethanol in a proton exchange membrane (PEM) electrolysis cell. Three Pt-Sn anodic catalysts with different nominal Pt:Sn ratios of 60:40, 70:30, and 80:20 atomic (at.) % were synthetized and characterized by the means of electrochemical tests and XRD. Among them, the Pt-Sn anodic catalyst with 70:30 at. ratio showed the highest electrochemical active surface area (ECSA) and highest electrochemical reforming activity, which allowed the production of pure H2 with the lowest electrical energy requirement (below 23 kWh·kgH2−1). The stability of the system was also demonstrated through a long-term chronopotentiometry experiment of 48 h in duration. The potential for practical use and coupling this technology with renewable solar energy, a number of cyclic voltammetry tests (with a low scan rate of 0.19 mV·s−1) were also carried out. These experiments were performed by simulating the electrical power produced by a photovoltaic cell. This test showed good stability/reproducibility of the MEA and, hence, a suitable integration between the two technologies for the sustainable energy storage in the form of hydrogen. [Figure not available: see fulltext.].