Source model for the M w 6.0 earthquake in Jiashi, China on 19 January 2020 from Sentinel-1A InSAR data

Abstract

On January 19, 2020, an Mw 6.0 earthquake occurred in Jiashi, Xinjiang Uygur Autonomous Region of China. The epicenter was located at the basin-mountain boundary between the southern Tian Shan and the Tarim Basin. Interferometric Synthetic Aperture Radar (InSAR) is used to obtain the coseismic deformation field from both ascending and descending Sentinel-1A satellite images of the European Space Agency. The results showed that the coseismic deformation is distributed between the Kalping fault and the Ozgertaou fault. The earthquake produced significant deformation over an area of approximately 40 km by 30 km. The maximum and minimal displacements along the line of sight (LOS) are 5.3 cm and − 4.2 cm for the ascending interferogram and are 7.2 cm and − 3.0 cm for the descending interferogram, respectively. The fault geometry from the Multi peak Particle Swarm Optimization computation indicates that the seismogenic fault is a shallow low-dipping planar fault that is 4.58 km depth underground. The finite slip model inverted by the Steepest Descent Method implies that the rupture is dominated by a thrust fault. The slips are concentrated in a depth of 5–7 km with a maximum slip of 0.29 m. The estimated total seismic moment is 1.688 × 1018 Nm, corresponding to a magnitude of Mw 6.1. The seismogenic fault is the Kalping fault which has a listric structure. The coseismic deformation only occurred on the décollement layer and did not involve the ramp segment. The coseismic Coulomb stress changes have enhanced the stress on the deep margin of the Jiashi earthquake rupture area, indicating that there is still the possibility of strong earthquakes in this region in the future.[Figure not available: see fulltext.]