Technical note: Design of a large variable temperature chamber for heat stress studies in rabbits

Abstract

One of the major constraint factors for rabbit production consists of the environmental conditions and especially high temperatures that negatively affect reproduction and growth performance. For this reason, several studies have addressed the effects of heat stress and possible solutions to alleviate its impact on rabbit performance. This article describes the design and operating features of a large temperature chamber (13×4.7x×3.1 m) configured to house 42 rabbits. The probes consisted of temperature sensor model DS2438 and humidity sensor model HIH-5031. The system was controlled by an Arduino platform programmed by its Integrated Development Environment (IDE) software. The system takes a decision every minute: it connects the heating if the temperature is lower than programmed and connects exhaust fans if the temperature is over the programmed setting. To renew the indoor air, every 5 min the system switches off the heating and switches on the exhaust fans for 15 s. Two experiments (with and without animals) were carried out to test the temperature control accuracy. Firstly, without animals, 2 tests were performed: (i) adjusting the temperature of the climatic chamber to the control house temperature plus 10°C and (ii) based on daily minimum (32°C) and maximum (37°C) temperatures. Secondly, with animals, does were maintained (i) between a daily minimum (32°C) and maximum (37°C) for 48 h and (ii) between a daily minimum (25°C) and maximum (35°C) temperatures for 105 d. Mortality rates were noted in both tests. The results of comparing the measured temperature deviation from programmed temperature reported a coefficient of determination of 0.9850 and 0.9947, for plus 10°C and 32-37°C curves, respectively. In the animal tests, the determination coefficients were 0.9926 and 0.9928 for programmed curve in the range of 32 to 37°C and 0.9859, 0.9900 and 0.9901 for programmed curve in the range of 25 to 35°C. Survival of females in the temperature chamber was as expected for reproductive rabbit does: 100 and 82% in the 2 and 105 d trials, respectively. Results indicate that the chamber provided precise temperature control for the development of heat stress studies in rabbits. © WRSA UPV 2003.