Metal Hydride Hydrogen Storage (Compression) Units Operating at Near-Atmospheric Pressure of the Feed H2

Abstract

Metal hydride (MH) hydrogen storage and compression systems with near-atmospheric H2 suction pressure are necessary for the utilization of the low-pressure H2 produced by solid oxide electrolyzers or released as a byproduct of chemical industries. Such systems should provide reasonably high productivity in the modes of both charge (H2 absorption at PL ≤ 1 atm) and discharge (H2 desorption at PH = 2–5 atm), which implies the provision of H2 equilibrium pressures Peq PH when heated to TH = 90–150 °C. This work presents results of the development of such systems based on AB5-type intermetallics characterized by Peq of 0.1–0.3 atm and 3–8 atm for H2 absorption at TL = 15 °C and H2 desorption at TH = 100 °C, respectively. The MH powders mixed with 1 wt.% of Ni-doped graphene-like material or expanded natural graphite for the improvement of H2 charge dynamics were loaded in a cylindrical container equipped with internal and external heat exchangers. The developed units with a capacity of about 1 Nm3 H2 were shown to exhibit H2 flow rates above 10 NL/min during H2 charge at ≤1 atm when cooled to ≤20 °C with cold water and H2 release at a pressure above 2 and 5 atm when heated to 90 and 120 °C with hot water and steam, respectively.