Micro-computerized tomography assessment of fluorescence aided caries excavation (FACE) technology: Comparison with three other caries removal techniques

Abstract

Background The aim of this study was to determine the caries removal effectiveness (CRE) and minimal invasiveness potential (MIP) of four dentine caries removal methods. Methods After carious molars were scanned using micro-computerized tomography (micro-CT), dentine caries were removed by fluorescence aided caries excavation (FACE) technology, laser induced fluorescence (LIF), chemomechanical excavation (CME), and conventional excavation (CE). Micro-CT was then repeated. CRE was determined based on the volume of residual caries/initial caries (RC/IC) and the mean mineral density (MD) at the cavity floor. MIP was determined by measuring the volume of the prepared cavity/initial cavity (PC/IC). Results Among the four groups, the LIF group had the smallest RC/IC (0.08), the highest mean MD at the cavity floor (1.32 g/cm3) and the highest MIP (4.47). The CME group had the highest RC/IC (0.24), the lowest mean MD (1.01 g/cm3) and the lowest MIP (2.23). The CE group exhibited a more acceptable CRE (RC/IC = 0.13, mean MD = 1.21 g/cm3) but had a higher MIP (3.95). Both the CRE and MIP parameters of FACE technology were the second most acceptable (RC/IC = 0.12, mean MD = 1.13 g/cm3, MIP = 3.20) and did not differ significantly from the most acceptable. Conclusions FACE is an effective caries removal technology for removing infected dentine without significantly increasing cavity size. © 2013 Australian Dental Association.