Evaluation of microphone density for finite element source inversion simulation of a laboratory acoustic test

Abstract

Simulation of the response of a system to an acoustic environment is desirable in the assessment of aerospace structures in flight-like environments. In simulating a laboratory acoustic test a large challenge is modeling the as-tested acoustic field. Acoustic source inversion capabilities in Sandia’s Sierra/SD structural dynamics code have allowed for the determination of an acoustic field based on measured microphone responses—given measured pressures, source inversion optimization algorithms determine the input parameters of a set of acoustic sources defined in an acoustic finite element model. Inherently, the resulting acoustic field is dependent on the target microphone data. If there are insufficient target points, then the as-tested field may not be recreated properly. Here, the question of number of microphones is studied using synthetic data, that is, target data taken from a previous simulation which allows for comparison of the full pressure field—an important benefit not available with test data. By exploring a range of target points distributed throughout the domain, a rate of convergence to the true field can be observed. Results will be compared with the goal of developing guidelines for the number of sensors required to aid in the design of future laboratory acoustic tests to be used for model assessment.