The arrival directions of ray paths between a sound source and a receiving array can be determined by beamforming the array-recorded signals. And, when the array and the signal are well matched, directional resolution increases with increasing signal frequency. However, when the environment between the source and the receivers is inhomogeneous, the recorded signal may be distorted and beamforming results may be increasingly degraded with increasing signal frequency. However, this sensitivity to inhomogeneities may be altered through use of an unconventional beamforming technique that manufactures higher frequency information by summing frequencies from lower-frequency signal components via a quadratic (or higher) product of complex signal amplitudes. This presentation will describe frequency-sum beamforming, and then illustrate it with simulation results and near-field acoustic experiments made with and without a thin plastic barrier between the source and the receiving array. The experiments were conducted in a 1.0-meter-deep and 1.07-m-diameter cylindrical water tank using a single sound projector, a receiving array of 16 hydrophones, and 100 micro-second signal pulses having nominal center frequencies from 30 kHz to 120 kHz. The results from frequency-sum beamforming will be compared to the output of conventional delay-and-sum beamforming for different center frequencies. © 2013 Acoustical Society of America.
CITATION STYLE
Abadi, S. H., Van Overloop, M. J., & Dowling, D. R. (2013). Frequency-sum beamforming in an inhomogeneous environment. In Proceedings of Meetings on Acoustics (Vol. 19). https://doi.org/10.1121/1.4799027
Mendeley helps you to discover research relevant for your work.