Formability enhancement of en AW-5182 H18 aluminum alloy sheet metal parts in a flash forming process: Testing, calibration and evaluation of fracture models

Abstract

Currently, it is state of the art to use precipitation hardening 6000-series aluminum alloys to manufacture high-strength aluminum automotive parts by extrusion or in a cold forming process. Alternatively, it is also possible to produce such parts by the use of non-precipitation hardening 5000-series aluminum alloys in a work-hardened condition. Therefore, BENTELER Automobiltechnik GmbH developed a special sheet forming process, henceforth referred to as "flash forming process". The application of the flash forming process, consisting of a rapid heat treatment and a subsequent cold die stamping, increases the forming capability of the work-hardened 5000-series aluminum sheets and results in high-strength parts with a very good ductility and weldability. In addition, this thermal assisted forming process allows a cost-saving production of such high-strength aluminum parts due to lower material costs of 5000-series aluminum alloys than those of a 6000-series material. Furthermore, the weight-saving effects of "flash formed" parts can be higher compared to extruded or cold formed 6000-series aluminum alloys. The suitability of the process is evaluated by forming a commercial AW-5182 H18 aluminum sheet to a crash-relevant automotive part. However, to accurately simulate the flash forming process itself, a temperature dependent fracture model is necessary. Investigations on a coupon basis also showed that the effect of adiabatic heating due to plastic work cannot be neglected. In cooperation with Paderborn University, a detailed mechanical testing, aided by digital image correlation (DIC) and thermal imaging, is carried out to characterize the yield, hardening and fracture behavior at elevated temperatures. The experimental tests are followed by the calibration of a FLD and an incremental stress state dependent fracture model in LS-DYNA. Finally, the simulation models are validated on a cross die deep drawn cup.