Development of an integrated sacrificial sensor for damage detection and monitoring in composite materials and adhesively bonded joints

8Citations
Citations of this article
13Readers
Mendeley users who have this article in their library.

This article is free to access.

Abstract

Quality assurance of adhesively bonded joints is of vital importance if their benefits are to be exploited across a wide range of industrial applications. A novel lightweight, low-cost, non-invasive embedded sacrificial sensor is proposed, capable of detecting damage within an adhesively bonded joint, which could also be used in a laminated composite structure. The sensor operation uses changes in electrical resistance, increasing as the sensing material area diminishes with damage progression. Initial tests prove the sensor concept by showing that the electrical resistance of the sensor increases proportionally with material removal, mimicking the sensor operation. Thermography is used to verify the current flow through the sensor and that any localised heating caused by the sensor is minimal. Short beam interlaminar shear strength (ILSS) tests show that embedding sensors in a composite laminates did not cause a reduction in material interfacial structural performance. Finally, the in situ performance of the sensor is demonstrated in quasi-static tensile tests to failure of adhesively bonded single lap joints (SLJs) with sensors embedded in the bond line. Prior to crack initiation, an electrical response occurs that correlates with increasing applied load, suggesting scope for secondary uses of the sensor for load monitoring and cycle counting. Crack initiation is accompanied by a rapid increase in electrical resistance, providing an indication of failure ahead of crack propagation and an opportunity for timely repair. As the crack damage propagated, the electrical response of the sensor increased proportionally. The effect of the sensor on the overall structural performance was assessed by comparing the failure load of joints with and without the embedded sensor with no measurable difference in ultimate strength. The research presented in the article serves as an important first step in developing a simple yet promising new technology for structural health monitoring with numerous potential applications.

References Powered by Scopus

The Stresses in Cemented Joints

1407Citations
N/AReaders
Get full text

A carbon nanotube strain sensor for structural health monitoring

991Citations
N/AReaders
Get full text

Structural health monitoring techniques for aircraft composite structures

586Citations
N/AReaders
Get full text

Cited by Powered by Scopus

Damage monitoring methods for fiber-reinforced polymer joints: A review

42Citations
N/AReaders
Get full text

Lock-in thermography using miniature infra-red cameras and integrated actuators for defect identification in composite materials

18Citations
N/AReaders
Get full text

Debonding of carbon fiber veil interleaved adhesively bonded GFRP joints via Joule heating

12Citations
N/AReaders
Get full text

Register to see more suggestions

Mendeley helps you to discover research relevant for your work.

Already have an account?

Cite

CITATION STYLE

APA

Ólafsson, G., Tighe, R. C., Boyd, S. W., & Dulieu-Barton, J. M. (2021). Development of an integrated sacrificial sensor for damage detection and monitoring in composite materials and adhesively bonded joints. Structural Health Monitoring, 20(6), 3406–3423. https://doi.org/10.1177/1475921721989041

Readers' Seniority

Tooltip

PhD / Post grad / Masters / Doc 5

83%

Researcher 1

17%

Readers' Discipline

Tooltip

Engineering 4

67%

Computer Science 1

17%

Chemistry 1

17%

Save time finding and organizing research with Mendeley

Sign up for free