Impact of nose radius and machining parameters on surface roughness, tool wear and tool life during turning of AA7075/SiC composites for green manufacturing

Abstract

Green manufacturing demands least wastage. Minimum chip formation reduces adverse effect on environment. Nose radius has a major role in reducing development of chips. Selection of proper nose radius and machining parameters will reduce amount of chip, therefore protect the environment. In finish turning of Al alloy-SiC, nose radius wear mainly affect the surface feature of the final product. It is owing to the direct contact between the area of tool nose and the SiC particles during turning. This paper is focused on influence of tool nose radius and machining parameters on surface quality of AA7075/15 wt.% SiC (20 - 40 μm) composites and tool life of tungsten carbide inserts while dry turning. Response surface method (RSM) was utilized to find the roughness and tool life under numerous turning situations. Considering the single objective optimization of turning parameters, minimum roughness of 2.088 μm, was achieved at nose radius of 1.2 mm and maximum tool life of 6.72 min, was obtained at nose radius of 0.4 mm. Multi objective optimization by desirability analysis for minimum roughness and the maximum life of tool has shown that suitable value of nose radius is 0.4 mm. Multi objective optimization of both roughness of surface and life of tool results in 1.81% increase in surface roughness and 10.11% decrease in tool life. Abrasion was mainly found to be responsible for wear of tungsten carbide inserts, while turning of AA7075/15 wt.% SiC (20 - 40 μm) composites. Novelty of this research work is that so far no one has investigated impact of nose radius and machining parameters on surface roughness, tool wear and tool life during turning of AA7075/15 wt.% SiC composites. Outcome of this research work will be useful for vehicle, aeroplane, space and ship industry.