The influence of polyisocyanurate (PIR) facing on the heat transfer through the corners of insulated building partitions

Abstract

Prefabricated products made of polyisocyanurate (PIR) thermal insulation material covered with cardboard, plastic, aluminium or composite facings are used for thermal insulation of building envelopes. The facing of these products is selected according to their conditions of use, and the effect of the facing on the declared thermal properties of the product depend only on water vapor diffuse properties of the facing. However, at the corners of the building where these products are joined, facings can be in the direction of the heat flux movement and significantly increase heat transfer through the longitudinal thermal bridge formed in the corner of the building. After analysing the solutions for installation of PIR thermal insulation products on the walls and roof corners of buildings, calculations of the heat transfer coefficients of the linear thermal bridges were made, and the influence of various facings and different structural solutions on the heat transfer coefficient value of the thermal bridge was determined. Aluminium foil facing have the greatest influence, but other facings must also be considered. The structural solutions with the greatest increase in the heat transfer due to the effect of the facing were selected, and the influence to the thermal and air tightness properties of the structural solution when facing is removed were analysed, the stability of thermal properties of the thermal insulation material were analysed as well. Proposals for joining PIR thermal insulation products with heat-conductive facings in the corners of buildings were prepared.