An ANN-based temperature controller for a plastic injection moulding system

6Citations
Citations of this article
24Readers
Mendeley users who have this article in their library.

Abstract

This paper proposes an approach to an ANN-based temperature controller design for a plastic injection moulding system. This design approach is applied to the development of a controller based on a combination of a classical ANN and integrator. The controller provides a fast temperature response and zero steady-state error for three typical heaters (bar, nozzle, and cartridge) for a plastic moulding system. The simulation results in Matlab Simulink software and in comparison to an industrial PID regulator have shown the advantages of the controller, such as significantly less overshoot and faster transient (compared to PID with autotuning) for all examined heaters. In order to verify the proposed approach, the designed ANN controller was implemented and tested using an experimental setup based on an STM32 board.

Cite

CITATION STYLE

APA

Khomenko, M., Veligorskyi, O., Chakirov, R., & Vagapov, Y. (2019). An ANN-based temperature controller for a plastic injection moulding system. Electronics (Switzerland), 8(11). https://doi.org/10.3390/electronics8111272

Register to see more suggestions

Mendeley helps you to discover research relevant for your work.

Already have an account?

Save time finding and organizing research with Mendeley

Sign up for free