Effect of undercooling of austenite on strain induced ferrite transformation behavior

Abstract

Hot compression test of up to 70% reduction was performed to examine the effect of undercooling (ΔT=Ae3-Ar3) of austenite on strain induced ferrite (SIF) transformation behavior. The undercooling of austenite was controlled by applying various cooling rates from the austenitization temperature to the deformation temperature. In order to examine ferrite formation, the flow curve was measured and compared with the calculated flow stress of austenite. Fine ferrite grains with a size of 2μm were observed within prior austenite grains. Increasing ΔT was an effective way to increase the amount of SIF, when the applied reduction was relatively small. With heavy deformation, the amount of SIF was nearly the same regardless of ΔT, while ferrite grains became finer and equiaxed by dynamic continuous recrystallization after transformation. It was also found that the amount of reduction for onset of ferrite formation within austenite grain was reduced with increasing ΔT. The decrease of flow stress was observed compared with that of austenite, which was mostly from ferrite formation during the deformation.