Primary used sand reclamation process efficiency

Abstract

The results of the efficiency of the primary reclamation process as well as the influence of the used sand temperature and other process parameters on it are presented in this paper. A separate stand realized on a reduced scale was built, which is an analogous process of the primary reclamation treatment of spent foundry sands. The used sands were introduced to the crushing process in an agglomerated form in the way typically used in industrial devices. The primary reclamation process was realized on a set of four horizontal sieves with decreasing mesh clearances while maintaining their geometrical dimensions applied in the Regmas industrial device. The model system consists of a vibratory drive mounted on the table, allowing us to control the supply frequency of the vibratory motors within a range of 40-60 Hz as well as the computer system for measuring the vibration parameters and drive power. The used sand on the quartz matrix with the KALTHARZ U404 resin and 100T3 hardener was used in our investigations. The used sand was prepared under the following conditions: cubic-shaped elements made of the applied furan sand was compacted by vibrations then hardened and subjected to heating under controlled conditions (as a "simulation" of the overheating process taking place in the mold after pouring). Time functions of the crushing and sieving process in dependence of the overheating degree of the reference sand samples (100°, 200°, and 300°C) were investigated at various table vibration frequencies and feed loads of the sieve set. The relative index of the crushing ability was determined.