On the mechanics of the collision between India and Asia

Abstract

Field studies of active faulting in S Tibet indicate that Quaternary extension has been taking place at a rate of ≃1 cm yr -1 in a direction of ≃ 100°. This implies that underthrusting in the Himalayas now absorbs less than half of the total convergence between rigid India and Asia, the rest being taken up primarily by strike-slip faulting N of the collision belt. En échelon right-lateral, strike-slip faults in S Tibet now allow this corresponding eastward displacement of the plateau with respect to India. The reproducible pattern of faulting obtained from plane-strain indentation experiments on unilaterally confined blocks of plasticine suggests that this extrusion process has occurred during most of the collision history. The Tertiary geological record in SE Asia corroborates a polyphase extrusion model, with displacements in excess of 1000-1500 km, in which India has successively pushed Sundaland, then Tibet and S China towards the ESE. Most of the Middle Tertiary movements may have occurred along the then left-lateral Red River-Ailao Shan Fault Zone, together with the opening of most of the eastern S China Sea. Regional geology, stratigraphy and deformation observed in Yunnan are consistent with this inference, as well as the timing, geometry and rates of sea-floor spreading in the S China Sea. Fast spreading (5 cm yr -1) in that sea implies that the Tibetan highlands formed mostly after 17 Ma BP. Sideways movements can also account for the existence of large, conjugate but asymmetric, Tertiary strike-slip faults within Sundaland and the formation of Middle Tertiary pull-apart and rift basins on the Sunda Shelf. Changing directions of opening are predicted in the Mergui and Andaman Basins and the lowlands of Burma, as well as large right-lateral displacements along the Shan Scarp. Most of Sundaland probably lay initially in a frontal position with respect to impinging India and the Shan Plateau may have been a Middle Tertiary analogue of the present Tibetan Plateau. In contrast with dominant overthrusting in the Himalayas, Tertiary strike-slip faulting, with more subordinate folding and thrusting, appears to have been important along and N of the Zangbo Suture. This difference must be accounted for in all models of formation of the Tibet Plateau. The surface of the indentation mark, left by the impaction of India onto the presumably simpler Early Tertiary margin of Asia (> 6 million km 2), implies that mountain building and strike-slip faulting have absorbed, perhaps alternately, roughly equal amounts of collisional shortening. Since analogous interplays of extrusion and thickening probably govern the evolution of most collision zones, the Tertiary tectonics of Asia may be the best guide to unravel the interactions between Palaeozoic and Precambrian plates, for which sea-floor spreading constraints are unattainable. © 1986 The Geological Society.