Low-Cost, Point-of-Care Potassium Ion Sensing Electrode in EGFET Configuration for Ultra-High Sensitivity

Abstract

This paper presents the development of a non-toxic and low-cost potassium ion sensor utilizing an Extended Gate Field-Effect Transistor (EGFET) configuration with all-solid-state electrodes fabricated on a printed circuit board (PCB) substrate. An Ag/AgCl-based pseudo-reference electrode (PRE) has been fabricated planar to a ion-selective membrane (ISM) coated on the gold solid-contact electrode (SCE). The PRE has shown < 1~mV/day drift potential, exhibiting exceptional stability and reproducibility. While the SCE has demonstrated a high sensitivity of 49~mV/log[K+] , covering a wide linear detection range from 10-4~M to 1~M with a rapid response time of less than 10 seconds. The sensor has displayed minimal hysteresis (< 15~mV ) and remained stable over a broad pH range (pH~4 to pH~10 ). These uni-planar, all-solid-state electrodes along with off-the-shelf FET mitigate the requirement of additional wire bonding by utilizing a common PCB platform for sensing as well as circuitry area. Additionally, the PRE, SCE and the FET in the EGFET-configuration-based sensing system have exhibited a high current sensitivity of 1.43~(μ A)1/2/log[K+]. Our sensor presents a practical and reliable solution for soil nutrient measurement in precision agriculture, offering significant advantages over existing potassium sensors in terms of cost-effectiveness, sensitivity, stability, and environmental safety. The presented approach holds promise for optimizing agricultural productivity and minimizing environmental impact through efficient nutrient monitoring and smart irrigation and fertilization management systems.