Comparison of axial magnetic gears based on magnetic composition topology differences

Abstract

This paper proposes a design and implementation of an axial type magnetic gear (MG) based on the composition of the magnetic arrangement. We report a quantitative comparison of two MG topologies with rectangular magnets arranged in series and parallel. Increased magnetic flux is done through magnetic circuit analysis and electrical circuit approach. Testing is done by using the rotation of a DC motor drive from 300-2600 rpm with a DC generator under load conditions. Measurement of load current and generator output power for both axial MG topologies are taken and analyzed. The results showed that the performance of an axial MG with the rectangular magnetic arrangement in parallel is better than that of a series arrangement. Based on the measured loading current of the two axial MG topologies, at generator rotation between 300-1300 rpm with 100, 200, and 300 ω resistance loads show the same load current. Conversely, after a DC generator rotation approaches 12 of the maximum rotation (1300-2600 rpm) there is a significant increase in load current fluctuations. That is, with an increase of load currents occurring, the parallel magnetic topology shows an increase in load torque due to an increase of magnetic flux in the gear train magnets of the MG.