Cage speed of hydrodynamic rolling hybrid bearings

Abstract

Hydrodynamic bearings are subjected to wear during starts and stops due to the absence of sufficient film pressure to effect complete separation of the sliding surfaces. In an earlier publication, our group reported the development of a new hydrodynamic rolling hybrid bearing (HRHB) to overcome the wear problem in hydrodynamic bearings. In the configuration, the transition of operation modes between the rolling bearing supporting state and the hydrodynamic bearing supporting state was realized by the clearance of the rolling bearing. Here we report on the development of a method to identify the operation modes for HRHBs based on monitoring the cage speed of the rolling bearing. The variation of cage speed with the shaft speed is measured. The effects of external load and starting time on the cage speed are also investigated experimentally. The results show that variation in the cage speed reflects changes in the load on the rolling bearing, as well as the operation modes of the HRHBs. With increases in the shaft speed, the variation in the cage speed presents three stages: the increasing stage, the decreasing stage, and the stationary stage. In the first two stages, the HRHB works at the rolling bearing supporting state while in stationary stage, the HRHB works at the hydrodynamic bearing supporting state. In additions to its property of no wear sufferance during starts and stops, compared to hydrodynamic bearings there is little risk of catastrophic failure with HRHBs during any interruption to the lubricant supply and compared to rolling bearings there is no fatigue failure. Therefore this hybrid design is useful at very high speeds. © 2013 Springer Science+Business Media New York.