Cu/Nb-Ti MRI wires with improved stability by incorporating filaments of large heat capacity substance PrB6

Abstract

In this paper we report our recent research on thermal stabilization of low-temperature superconducting magnets by means of large heat capacity substances (LHCS). Two samples (lengths ∼100 m) of NbTi composite wires with additional internal filaments made from intermetallic compound PrB6 (5.9-7.3 vol.%) were produced and tested. The design of the wires was similar to that of the conventional MRI sc wires, except for their smaller diameter (0.835 mm instead of 1.345 mm). Our final goal was the investigation of the possibility to minimize (or even eliminate completely) the necessity of MRI magnets training before their commissioning. The comparative stability measurements showed a twofold increase of the minimum quench energies (MQEs) of the doped wires against short heat disturbances. The magnetic field corresponding to the first flux jump increased by 50%. In MQE tests, the PrB6 heat capacity was fully utilized over the course of a 1 ms heat pulse. In the thermomagnetic stability measurements, the efficiency of LHCS doping was about 75% due to the fast evolution of the flux jumps.