Additive manufacturing with the lightweight material aluminium alloy EN AW-7075

Abstract

As a widely used additive manufacturing technique, the laser metal deposition process (LMD) also known as direct energy deposition (DED) is often used to manufacture large-scale parts. Advantages of the LMD process are the high build-up rate as well as its nearly limitless build-up volume. To manufacture large-scale parts in lightweight design with high strength aluminium alloy EN AW-7075, the LMD process has a disadvantage that must be considered. During the process, the aluminium alloy is melted and has therefore a high solubility for hydrogen. As soon as the melt pool solidifies again, the hydrogen cannot escape the melt and hydrogen pores are formed which weakens the mechanical properties of the manufactured part. To counter this disadvantage, the hydrogen must be successfully kept away from the process zone. Therefore, the covering of the process zone with shielding gas can be improved by an additional shielding gas shroud. Furthermore, the process parameters energy input per unit length as well as the horizontal overlapping between two single tracks can be varied to minimize the pore volume. Best results can be achieved in single tracks with an elevated energy input per unit length from 3000 to 6000 J/cm. To manufacture layers, a minimal horizontal overlapping will lead to lowest pore volume, although this results in a very wavy surface, as a compromise of low pore volume and a nearly even surface a horizontal overlapping of 30 to 37% leads to a pore volume of 0.95% ± 0.50%.