Optimization of Machining Parameters for AISI 316L And 317L Austenitic Stainless Steels using Eco Cut Wire EDM Technique

Abstract

Austentic stainless steel is one of the most suitable engineering material based on their superior resistance to corrosion and compatibility at high temperatures and high vacuum. However, the machinability of austenitic stainless steel is not very promising owing to lower thermal conductivity, higher degree of ductility and work hardenability. For meeting these challenges, unconventional machining procedures were evolved and can make any impenetrable design/profile on any work substance by acceptable controlling of various machining procedures. The main importance of this paper is to show the impact of machining parameters on Eco-cut Wire Electric Discharge Machining (WEDM) for disparate austenitic stainless steels (AISI 316L & 317L). Initially both the metals are machined on WEDM. Machining parameters like pulse on time(Pon), pulse off time(Poff), voltage(V) and wire tension(WT) are observed for both 316L and 317L stainless steel materials. A Box-Behnken Design (BBD) of response surface methodology (RSM) has been used for experimental work. The reaction of procedure is estimated by ANOVA analysis and response optimizer is used for optimum level checking. A series of trial runs were carried out on both the machined specimens for identifying better material removal rate(MRR), cutting speed(CS) and surface roughness(Ra).