Does the use of 3D-printed cones give a chance to postpone the use of megaprostheses in patients with large bone defects in the knee joint?

Abstract

Revision procedures and the resulting bone loss are a big challenge for orthopedic surgeons. Therefore, we checked what functional outcomes that 3D-printed cone augments can offer to patients with bone defects (Anderson Orthopedic Research Institute [AORI] classification type 2B and 3) in the knee and whether the use of cones can delay the necessity to use a megaprotheses. Data from 64 patients (M = 22; W = 42) who underwent total knee arthroplasty (TKA) revision were included in the analysis. The Knee Society Clinical Rating System (KSS) and the range of motion in the knee joint were used for the functional assessment. The mean follow-up was 28 months (range: 18–44 months). The survival rate for aseptic loosening at follow-up was 100%. Infection occurred in two (3.1%) patients. The mean KSS score increased from 12.75 points preoperatively to 66.56 post-operatively (p < 0.001). The mean range of motion in the knee changed from 61.15° preoperatively to 115.93° post-operatively (p < 0.001). 3D-printed cone augments seem to be a good solution for patients requiring a TKA revision procedure. When used in patients with bone defects classified as 2B and 3 (AORI), they can be a good alternative, delaying the need for megaprotheses.