Experimental research on increasing the static torque for a small Savonius rotor of helical type

Abstract

A small Savonius wind turbine of helical type was tested in an open jet wind facility for identifying the optimum position of the rotor blades aiming the maximization of static torque. The two blades of the wind turbine of U shape were twisted up to 1800 from bottom to top and three values for blade overlap were considered i.e. 0.35, 0.2 and 0.0. The turbine torque was measured for no load conditions and wind velocities between 2-8 m/s. In the same time the air flow through Savonius rotor was observed by using a visualization setup aiming to identify the correlation between the torque and the flow pattern inside the returning blade at rotating angles where the torque has highest values. Best results for the torque coefficient of 0.72 and power coefficient of 0.265 were obtained at a wind velocity of 5.8 m/s and low overlap ratio of 0.2. By measuring the overall torque of the rotor for each case study, the positive effect of pressure recovery was explained as a result of air flow through the blade overlap from the concave side of the advancing blade to concave side of the returning blade for a certain interval of the rotating angle a = 50-60 .