An In Vitro Study to Evaluate the Effect of Artificial Aging on Translucency, Contrast Ratio, and Color of Zirconia Dental Ceramic at Different Sintering Levels

Abstract

Increasing demands for aesthetically pleasing dental restorations have promoted the use of materials that display superior optical properties. Zirconia-based all-ceramic systems have good optical properties, thus providing the desired esthetics for dental restorations. The altered oral conditions impact the physical properties of these materials. Multiple studies have been conducted to evaluate the effect of aging on the mechanical properties of computerized-aided design and computerized-aided manufacturing (CAD/CAM)-based zirconia; however, there is a scarcity of literature discussing the effect of aging on change in translucency, contrast ratio, and color. Therefore, this research aimed to evaluate the effect of accelerated artificial aging on translucency parameter (TP), contrast ratio (CR), and color of CAD/CAM zirconia at different sintering temperatures. Twenty-eight rectangular-shaped specimens were obtained by CAD/CAM milling of zirconia blank. Sintering of the samples was carried out at four different temperatures 1350◦C, 1400◦C, 1450◦C, and 1500◦C, respectively. Thermocycling of the samples was performed in a thermocycler. TP, CR, and color evaluation of all the samples was done again using a Spectrophotometer. Data acquired were statistically evaluated by one-way ANOVA and Post Hoc test. The highest amount of change in TP was recorded for specimens sintered at 1400◦C (1.86), whereas the least change was attributed to 1350◦C (0.51). The highest change in CR was observed in specimens sintered at 1500◦C (0.0971), and the least change in CR was observed at 1450◦C (0.0086). The highest ∆E values were recorded for 1400◦C against both white (1.86) and black background (2.17), whereas the least change was attributed to 1350◦C against white (0.86) and against a black background (1.41). The changes in TP were significant, but CR did not show any significant change. ∆E values for all the experimental groups were significant, but were below the clinically perceptible range. An increase in sintering temperature increased the translucency.