A CAD CAM method for custom below-knee sockets

Abstract

The purpose of this investigation was to develop a numerical method for fabricating prosthetic sockets for below-knee amputees. An opticalllaser digitiser scans an amputee's stump and collects three dimensional numerical data describing the surface of the limb and describing specific modification site locations. The numerical data from the laser camera representing the stump and modification sites are altered by the prosthetist using a custom computer aided design software system running on a personal computer. Using the altered numerical data a programme is created for a high resolution numerically controlled milling machine and a mould is made. The prosthetist then fabricates a socket. While the system has been tested with below-knee amputees it has been designed for application in most areas of prosthetics and orthotics. Utilising this method 15 patients were fitted. All patients sujectively stated that their computer designed socket fitted better than their conventionally made socket. As the research progressed and experience was gained with the system patients were normally fitted with the first socket iteration. The system overcomes five limitations existing with some of the other numerical systems: 1) accurate high resolution surface topography, 2) specific identification of subject modification sites, 3) flexible, user friendly software, 4) high resolution numerically controlled milling, and 5) integrated expansion to other prosthetic and orthotic areas. © 1992, SAGE Publications. All rights reserved.