Design of efficient loadcell for measurement of mechanical impact by piezoelectric PVDF film sensor

Abstract

Conversion efficiency of mechanical impact into electrical voltage remains ever increasing demand for piezoelectric PVDF film sensor. For a given film sensor, the output voltage produced due to mechanical impact is highly dependent on the direction of stretching (or compressing) and active area of the film sensor. More is the active area of the film; higher will be the output voltage. It is shown that the active area is significantly increased due to the ridge-like shape given at the inner surfaces of the plates of sandwich type loadcell and as a result of which higher conversion efficiency is obtained. The effectiveness of the ridge-like shape is confirmed statistically by conducting two factorial design of experiment in which shape and material of the loadcell are considered as the two factors with 2×4 matrix. In case of loadcell made of glass plates, more than 100% increase in the output voltage is observed for ridge-like shape in comparison to its plain counterpart. Both the bandwidth and frequency range of the output signal is found to be independent and dependent of the loadcell materials for indirect and direct impact with the loadcell respectively. The merits and demerits of the fabricated loadcells are discussed.