Numerical investigations on thermal forming limit testing with local inductive heating for hot forming of aa7075

Abstract

Forming 7000‐series aluminum alloys under elevated temperatures is particularly attrac-tive due to their increased formability. To enable process design by finite element simulation for hot forming, strain‐based criteria, such as temperature‐dependent forming limit diagrams (TFLD), can be consulted to assess forming feasibility. This work numerically investigates the extent to which in‐plane experimental concepts with partial inductive heating are suitable for detecting discrete failure points in TFLD. In particular, an alternative to the currently widely used thickness‐reduced specimen geometries was created for cruciform specimens under biaxial tension. First, the temper-ature‐dependent and strain‐rate‐dependent flow behavior was investigated for AA7075 under uni-axial tension. A heat source model for partial inductive heating was inversely parameterized based on heating experiments. Subsequently, the test procedures were simulated with different specimen geometries under discrete strain conditions. Different concepts were discussed for deriving a suitable specimen shape for the biaxial tension case, and the influence of different notch and slot forms were shown. The simulations showed that partial inductive heating was suitable to induce failure situations, thus creating TFLDs. For the biaxial tension case, a sufficiently large temperature gradient was required to use cruciform specimens without thickness reduction.