Editors' Choice—Improving Quality of EDMed Micro-Holes on Titanium via In Situ Electrochemical Post-processing: A Transient Simulation and Experimental Study

Abstract

Electrical discharge micromachining (EDM) poses challenges to the fatigue-life performance of machined surfaces due to thermal damage, including recast layers, heat-affected zones, residual stress, micro-cracks, and pores. Existing literature proposes various ex situ post-processing techniques to mitigate these effects, albeit requiring separate facilities, leading to increased time and costs. This research involves an in situ sequential electrochemical post-processing (ECPP) technique to enhance the quality of EDMed micro-holes on titanium. The study develops an understanding of the evolution of overcutting during ECPP, conducting unique experiments that involve adjusting the initial radial interelectrode gap (utilizing in situ wire-electrical discharge grinding) and applied voltage. Additionally, an experimentally validated transient finite element method (FEM) model is developed, incorporating the passive film formation phenomenon for improved accuracy. Compared to EDM alone, the sequential EDM-ECPP approach produced micro-holes with superior surface integrity and form accuracy, completely eliminating thermal damage. Notably, surface roughness (Sa) was reduced by 80% after the ECPP. Increasing the voltage from 8 to 16 V or decreasing the gap from 60 to 20 μ m rendered a larger overcut. This research’s novelty lies in using a two-phase dielectric (water-air), effectively addressing dielectric and electrolyte cross-contamination issues, rendering it suitable for commercial applications. Better micro-hole quality through in situ sequential eco-friendly near-dry EDM & ECM Successfully resolved dielectric-electrolyte cross-contamination in sequential processes Unique experiments that adjust the initial radial IEG using in situ wire-EDG Developed and validated a transient FEM model, incorporating passivation aspect Achieved recast layer-free holes with Sa values approximately 80% lower than EDM holes