The surface morphology of a Ti-6Al-4V fiber-lasered nitride layer

Abstract

A fiber laser was used to nitride Ti-6Al-4V titanium alloy the effect of the process parameters on the surface morphology was studied. The surface chemical composition of the nitride layer and the phase of black powder on the surface were analyzed, the two-dimensional and three-dimensional surface topography of the nitride layer surface were measured, and the cross-section microstructure of the nitride layer was photographed. The effects of laser power, laser scanning speed, nozzle distance, and nitrogen flow rate on the surface morphology were studied. The experiments show that the laser power mainly affects the surface oxidation, the laser scanning speed mainly affects the surface roughness, and the nozzle distance has a great influence on the surface morphology. The gas flow rate, however, had a slight effect on the surface morphology. A large heat input and a high nitrogen flow rate caused an increase in TiN and TiO2 black powders. Surface oxidation did not affect the formation of a continuous TiN layer nor surface roughness. Finally, the critical energy density leading to increased surface roughness was calculated.