High pressure hugoniot measurements using mach waves

Abstract

Traditionally, most dynamic shock compression experiments are conducted using a plane one-dimensional wave of uniaxial strain. In this case, the evaluation of the equation of state is simplified due to the geometry, but the amplitude of the induced shock wave is limited by the magnitude of the input load. In an effort to dramatically increase the range of pressures that can be accessed by traditional loading methods, a composite target assembly is examined. The target consists of two concentric cylinders aligned with the axial direction parallel to the loading. The target is designed such that on initial loading, the outer cylinder will have a higher shock velocity than the inner material of interest. Conically converging shocks will be generated at the interface between the two materials due to the impedance mismatch. Upon convergence, an irregular reflection occurs and the conical analog of a Mach reflection develops. The Mach reflection will grow until it reaches a steady state, at which point the wave configuration becomes self similar. The resulting high pressure Hugoniot state can then be measured using velocity interferometry and impedance matching. The technique is demonstrated using a planar mechanical impact generated by a powder gun to study the shock response of copper. Two systems are examined which utilize either a low impedance (6061-T6 aluminum) or a high impedance (molybdenum) outer cylinder. A multipoint VISAR experiment will be presented to validate the technique, and will be compared to numerical simulations. The feasibility of measuring an entire Hugoniot curve using full field velocity interferometry (ORVIS) will also be discussed. © 2012 American Institute of Physics.